Engineering, 05.03.2020 22:44 isabellam646

Consider a propeller driven aircraft which is to cruise at 150 mph at 10,000 ft altitude using a 6 ft diameter propeller driven at 2500 rpm. The performance specifications for this plane are to be determined based on testing a 1 ft diameter scale model propeller at 150 mph freestream velocity in a wind tunnel at SEA LEVEL. Determine: (a) what engine rpm is required (for the model testing) IF proper scaling is desired and (b) how much thrust is developed by the full scale propeller if the scale model propeller of part (a) develops a thrust of 50 lb.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

You know the right answer?

Consider a propeller driven aircraft which is to cruise at 150 mph at 10,000 ft altitude using a 6 f...