Engineering, 04.03.2020 17:13 kiiya33

Logical variables: Running late? Complete the tunction RunningLate such that the logical variable on Time is true if no Traffic is true and gasEmpty is false. Ex >> n°Traffic = true ; >> gasEmpty-false; >onTime - Runninglate(noTraffic, gasEmpty) logical Your Function B Save C Reset EE MATLAB Documentation 1 function onTime - RunningLate (noTraffic, gasEmpty) 2 % complete the logical expression to the right of . using the variables n°Traffic and gasEmpty 4 onTime - 6 end Code to call your function C Reset 1 noTraffic true; gasEmpty true; 2 onTime-Runninglate(noTraffic, gasEmpty)

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Engineering, 04.07.2019 19:10, Mimidj9279

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 04.07.2019 19:10, nhester3401

Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.

Answers: 2

continue

You know the right answer?

Logical variables: Running late? Complete the tunction RunningLate such that the logical variable on...