Engineering, 03.03.2020 18:10 pbargy9551
Fix the code so the program will run correctly for MAXCHEESE values of 0 to 20 (inclusive). Note that the value of MAXCHEESE is set by changing the value in the code itself. If you are not sure of how it should work then look at the Sample Runs of the next part. This part handles the beginning where it lists all the cheese types available and their prices. Note: it is a very simple fix that needs to be added to all the statements that have an array access.
Answers: 2
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Fix the code so the program will run correctly for MAXCHEESE values of 0 to 20 (inclusive). Note tha...
History, 18.02.2021 19:40
Mathematics, 18.02.2021 19:40
Social Studies, 18.02.2021 19:40
History, 18.02.2021 19:40
Mathematics, 18.02.2021 19:40