Engineering, 02.03.2020 17:58 winterblanco

A Brayton cycle gas engine is analyzed using the air standard method. Given the conditions at state 1, pressure ratio (rp), and cutoff ratio (rc) determine the efficiency and other values listed below. The specific heat ratio and gas constant for air are given as k=1.4 and R=0.287 kJ/kg-K respectively.--Given Values--T1 (K) = 337T2 (K) = 647P1 (kPa) = 169rp = 10.3rc = 1.85AV (m3/s) = 1.4Specific Enthalpy at State 1= 337.396Relative pressure at State 1= 2.0849Relative pressure at State 2= 21.5e) Determine the pressure (kPa) at state 2. f) Determine the specific enthalpy (kJ/kg) at state 2. g) Determine the temperature (K) at state 3. h) Determine the pressure (kPa) at state 3. i) Determine the specific enthalpy (kJ/kg) at state 3. j) Determine the relative pressure at state 3 k) Determine the relative pressure at state 4 1) Determine the temperature (K) at state 4. m) Determine the pressure (kPa) at state 4. n) Determine the specific enthalpy (kJ/kg) at state 4 o) Determine the mass flow rate (kg/s) through the engine. p) Determine the net power output (kW) for the engine. q) Determine the rate of heat addition (kW) for the engine. r) Determine the efficiency (%) of the engine.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

You know the right answer?

A Brayton cycle gas engine is analyzed using the air standard method. Given the conditions at state...