Engineering, 27.02.2020 21:44 hejdiidid9311
On a breadboards, hook up an IR LED to provide an infrared light source for signaling the phototransistor as shown in Figure 2 below. Use a pushbutton switch to turn the IR LED on and off. Note that the pushbutton does not require any resistors to ground as it only needs to control when the power enters the power rails on your protoboard. The IR LED will drop approximately 1.35 volts and should be operated with ~100 mA of current.
Q1: Calculate the value required for the resistor labeled R in the circuit below to achieve these design specifications.
Q2: Now calculate the power that you expect this resistor to absorb (remember the formulas for power in terms of current and resistance)
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:20, alexis9263
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20, yasyyas646646
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
Engineering, 04.07.2019 19:10, shunna33
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
You know the right answer?
On a breadboards, hook up an IR LED to provide an infrared light source for signaling the phototrans...
Questions in other subjects:
Geography, 29.03.2021 18:00
