Engineering, 27.02.2020 17:57 karyme12

A piston cylinder assembly fitted with a slowly rotating paddle wheel contains 0.13 kg of air at 300K. The air undergoes a constant pressure process to a final temp of 400K. During the process heat is transfered to the air by Q=12kJ. Assuming the ideal gas model with k=1.4 and negligible changes in kinetic and potential energy for the air, determine the work done by the paddle on the air and the work done by the air to displace the piston. Gas constant for air is 0.287 kJ/kg*K

note ideal gas model is pV=mRT, and with k=1.4 the total internal energy change of air canbe calculated by U2-U1=(mR/k-1)(delta T)

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, mjcbs21

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

continue

Engineering, 04.07.2019 18:20, cdyshaylia55

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

You know the right answer?

A piston cylinder assembly fitted with a slowly rotating paddle wheel contains 0.13 kg of air at 300...