subject
Engineering, 27.02.2020 03:19 malibu777

An engineer is installing an open-end mercury manometer attached to a pipe that will eventually carry pressurized gas. While the pipe is open to the atmosphere, she adds enough mercury into the manometer that the mercury level in both arms of the manometer is 740.0 mm above the bottom of the manometer. If the end of the open arm of the manometer is 1025.0 mm above the bottom of the manometer, what is the maximum pressure (gauge) of the pressurized gas that the pipe can carry before the mercury spills out the open end the manometer?

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, jadeochoa4466
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
image
Engineering, 04.07.2019 18:10, katelynn73
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
image
Engineering, 04.07.2019 19:20, mariahmimibrooks
Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.
Answers: 2
image
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
You know the right answer?
An engineer is installing an open-end mercury manometer attached to a pipe that will eventually carr...

Questions in other subjects:

Konu
Mathematics, 26.03.2021 23:00
Konu
Physics, 26.03.2021 23:00
Konu
Mathematics, 26.03.2021 23:00