Engineering, 26.02.2020 18:01 oKINGDEROo

Fuel filters are being replaced on a HPCR diesel
engine. The technician should perform all of the fol-
lowing steps, EXCEPT:
A fill the filters with fuel before installing them
B. lubricate the filter gaskets before installation
C. prime the filters before starting the engine
D. use the primer pump to remove air from
the system

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bunnles

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

You know the right answer?

Fuel filters are being replaced on a HPCR diesel
engine. The technician should perform all of t...