Engineering, 26.02.2020 05:12 halohero7

An AISI 1030 hot rolled steel bar has a diameter of 1.5in. For unknown factors including the reliability factor, set equal to 1.

Estimate the:

a. Endurance limit (Se’)

b. Corrected endurance limit in bending and rotation (Se). Assume that there is no axial loading. Assume that component is used at room temperature. Assume that a 50% reliability that the endurance strength of your material is within 8% of the mean value reported is acceptable.

c. Corrected endurance limit for reverse bending without rotation (Se). Assume that there is no axial loading. Assume that component is used at room temperature. Assume that a 50% reliability that the endurance strength of your material is within 8% of the mean value reported is acceptable. Note: the size factor will change compared to previous question.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

You know the right answer?

An AISI 1030 hot rolled steel bar has a diameter of 1.5in. For unknown factors including the reliabi...