subject
Engineering, 26.02.2020 03:14 chant9

You have been asked to design a flexible pavement and the following daily traffic is expected for design: 6375 passenger cars with two 2-kip single axles, 375 18-wheel trucks with one 12-kip single axle and two 32-kip tandem axles, 225 triple-trailer trucks with one 18-kip single axle and six 36-kip tandem axles, and 525 single unit trucks with one 10-kip single axle and one 24-kip tandem axle. There are 3 lanes in the design direction (conservative design is to be used). Assuming a structural number of 5.0, determine the design-lane 18-kip ESALs for the pavement projected 15-year design life with the TSI of 2.5

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
image
Engineering, 04.07.2019 18:20, mjcbs21
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
image
Engineering, 04.07.2019 18:20, kendrawalraven
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
You know the right answer?
You have been asked to design a flexible pavement and the following daily traffic is expected for de...

Questions in other subjects:

Konu
Biology, 14.04.2020 18:21