subject
Engineering, 25.02.2020 22:54 emmamood

Your program should do the following: 1. Interactively request and read in the initial altitude (in Km) and fuel supply (in Kg) of the Enterprise as well as the strength of the Deltoid's tractor beam (in Km/min/min). Your program must allow someone entering these data items to do so repeatedly, allowing for multiple simulations. Do this by asking the user to enter a 'y' or 'n' before each simulation, indicating whether or not a new simulation should be run at that time. 2. Compute the amount of fuel required to escape from that altitude. The amount required can be calculated using this formula: fuel_required = (1 - altitude / 200000) * beam_strength 3. If there is sufficient fuel available, recommend escaping at once. 4. If there is insufficient fuel available, advise Captain Kirk to turn off the engines and have Scotty start shoveling. If we don't turn off the engines, Scotty might get toasted when he opens the fuel door. 5. Your program should then display a minute-by-minute status report on the Enterprise's condition. This report should continue until the Enterprise has enough fuel to escape the planet, or the ship crashes. 6. Based on the results of your report, tell the Captain how long he should wait before starting the engines, or how long before the ship will crash.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 19:30, 10040813
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
image
Engineering, 06.07.2019 02:30, khalilh1206
1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction
Answers: 1
image
Engineering, 06.07.2019 03:20, demotte79991
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
image
Engineering, 06.07.2019 04:20, Jana1517
Consider a beam traveling through diamond and impinging upon the diamond-air interface. the critical angle of incidence for total internal reflection to occur is closest to the following value: select one: a)-22.50° b)-23.85 c)-24.30 d)-23.40° e)-none of the above
Answers: 3
You know the right answer?
Your program should do the following: 1. Interactively request and read in the initial altitude (in...

Questions in other subjects:

Konu
Mathematics, 20.10.2020 03:01
Konu
Mathematics, 20.10.2020 03:01
Konu
Mathematics, 20.10.2020 03:01
Konu
Biology, 20.10.2020 03:01