Engineering, 25.02.2020 22:11 rostecorralmart

Injuries occurred outdoors on the school campus as a result of a collision between a student on a bicycle and a student on a skateboard. The students were riding at excessive speeds along a pedestrian-only sidewalk — one on the north side of the building and one on the west side. The collision occurred at the northwest corner of the building. The student on the bicycle suffered a sprained ankle and serious cuts to his head. He was transported to the emergency room for assessment of head trauma. The student on the skateboard suffered serious cuts to his left leg and scrapes to his left elbow. He was also taken to the hospital for stitches to repair his leg wounds. Neither student was wearing a helmet or other protective gear. (6 points)

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

You know the right answer?

Injuries occurred outdoors on the school campus as a result of a collision between a student on a bi...