Engineering, 25.02.2020 16:57 AADJ4

A strain gauge pressure sensor has the following specification. Will it be suitable for the measurement of pressure of the order of 100 kPa to an accuracy of +_5 kPa in an environment where the temperature is reasonably constant at about 20°C?
Specification:
Ranges: 2 to 70 MPa, 70 kPa to 1 MPa
Excitation: 10 V d. c. or a. c. (r. m.s.)
Full range output: 40 mV
Non-linearity and hysteresis errors: +_0.5%
Temperature range: - 54 to +120°C

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, danksans7011

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

continue

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

You know the right answer?

A strain gauge pressure sensor has the following specification. Will it be suitable for the measurem...