Engineering, 25.02.2020 04:30 Mathcat444

Two parallel, aligned disks, 0.4 m in diameter and separated by 0.1 m, are located in a large room whose walls are maintained at 300 K. One of the disks is maintained at a uniform temperature of 500 K with an emissivity of 0.6., while the backside of the second disk (disc 2) is well insulated. Room is large enough to be considered as a black body. Assuming the discs are diffuse, gray surfaces, answer the following questions:
(a) Compute the view factors F12 and F13 [2 points]
(b) Draw the radiation network for this problem [2 points]
(c) Write an equation for radiation balance at surface 1 [2 points]
(d) Write an equation for radiation balance at surface 2 [2 points]
(e) Compute the temperature of the second disk. [2 points]

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, kodyclancy

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

continue

Engineering, 04.07.2019 19:20, brae72

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

continue

You know the right answer?

Two parallel, aligned disks, 0.4 m in diameter and separated by 0.1 m, are located in a large room w...