Engineering, 25.02.2020 02:33 yehnerthannah

A hole of diameter D = 0.25 m is drilled through the center of a solid block of square cross section with w = 1 m on a side. The hole is drilled along the length, l = 2 m, of the block, which has a thermal conductivity of k = 150 W/m·K. The four outer surfaces are exposed to ambient air, with T[infinity],2 = 25°C and h2 = 4 W/m2·K, while hot oil flowing through the hole is characterized by T[infinity],1 = 330°C and h1 = 50 W/m2·K. Determine the corresponding heat rate and surface temperatures.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

You know the right answer?

A hole of diameter D = 0.25 m is drilled through the center of a solid block of square cross section...