Engineering, 20.02.2020 08:50 querty2400
A pair of mating gears have 20 degrees full-depth teeth with a diametral pitch of 8. Both gear and pinion are made of steel heat-treated to 350 Bhn, and both have a face width of 1 in. The teeth are cut with a top quality hobbing operation. The pinion has 20 teeth and rotates 1100 rpm. It is mounted outboard on the shaft of an eletric motor, and drives a 40-tooth gear that is positioned inboard on an accurately mounted blower shaft. The design life corresponds to 5 years of 60 hours/week, 50 weeks/year operation. Using a reliability of 99% and a safety factor of 1.5, estimate the horsepower that can be transmitted, based only on bending fatigue.
3. To what value could the gear hardness be reduced in Problem 2 without making the gear teeth weaker than the pinion teeth in bending fatigue?
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
You know the right answer?
A pair of mating gears have 20 degrees full-depth teeth with a diametral pitch of 8. Both gear and p...
Questions in other subjects:
Chemistry, 05.05.2020 22:03
