Engineering, 19.02.2020 00:47 Arealbot

For a bolted assembly with 8 bolts, the stiffness of each bolt is kb = 1.0 MN/mm and the stiffness of the members is km = 2.6 MN/mm per bolt. The bolts are preloaded to 75 percent of proof strength. Assume the external load is equally distributed to all the bolts. The bolts are M6 x1 class 5.8 with rolled threads. A fluctuating external load is applied to the entire joint with Pmax = 60kN and Pmin = 20kN. Determine the following:. A) Determine the yielding factor of safety. B) Determine the overload factor of safety. C) Determine the factor of safety based on joint separation. D) Determine the factor of safety using the Goodman criterion.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

Engineering, 04.07.2019 19:20, amcd2002

A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.

Answers: 2

continue

You know the right answer?

For a bolted assembly with 8 bolts, the stiffness of each bolt is kb = 1.0 MN/mm and the stiffness o...