Engineering, 18.02.2020 18:37 rawbabyjazz

A copy of a Pepco Home Energy Report for Dr. Louie when living in Maryland from Mar 22 – Apr 21, 2016 is attached at the end of this assignment. The total energy use for heating over the 31-day period was 95 kWh (which was 53% lower than other "efficient" homes in the area). Assume the only heat loss is through the insulation along the walls, and there is no movement of air or other flow in or out of the system. The estimated surface area of walls in contact with the outdoor air and indoor air is 560 ft2 . Based on historical records, the average outdoor temperature during this period was around 51 °F. Assume the indoor air temperature was held at an average of 67 °F, and the system is at steady-state. Calculate the R value for the insulation in ft2 ·°F·h/Btu

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, BardiFan

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

continue

Engineering, 04.07.2019 18:10, dval1146

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, kodyclancy

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

continue

You know the right answer?

A copy of a Pepco Home Energy Report for Dr. Louie when living in Maryland from Mar 22 – Apr 21, 201...