Engineering, 18.02.2020 03:37 rm3582317

Consider a power converter consisting of a full-wave rectifier that is used to convert ac mains line voltage (60Hz, 110Vrms) to a 6W load that requires 12Vdc. Your customer requires you to achieve a voltage regulation value of at least 0.90 and to have less than 10% ripple in your output voltage.

Determine the values of the series resistor, capacitor, and transformer turn ratio to meet the requested specifications.
Draw the voltage and current waveforms for the transformer secondary, the top left diode, the output capacitor, and load, labeling both axis with the actual values (i. e. extinction time, peak values, etc.). Determine the required average diode current and reverse voltage blocking requirement. You can approximate the capacitor and diode current as being square waveforms.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

Engineering, 04.07.2019 19:10, nayi2002

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

continue

You know the right answer?

Consider a power converter consisting of a full-wave rectifier that is used to convert ac mains line...