Engineering, 18.02.2020 03:28 Anshuman2002
A subsonic diffuser flow is steady and adiabatic with inlet Mach number M1 = 0.6. Total pressure loss in the diffuser is 2% of the inlet total pressure, i. e., pt2/ pt1 = 0.98. The diffuser area ratio is A2/ A1 = 1.50. Assuming that the flow in the diffuser has a uniform exit flow, calculate the exit Mach number M2 the static pressure recovery in the diffuser CPR the (internal) force acting on the diffuser, i. e., Fx, wall, nondimensionalized by the inlet static pressure and area,
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
A subsonic diffuser flow is steady and adiabatic with inlet Mach number M1 = 0.6. Total pressure los...
Questions in other subjects:
Biology, 20.03.2020 00:00
