Engineering, 17.02.2020 21:17 blake2001

You have tiles of two different fixed sizes, 1ft and 5ft long, and you want to decide whether a certain number of these tiles can fit exactly a certain length (we do not care about the other dimension). It’s ok if you have more tiles than needed but not the opposite obviously. Parameters: num_small (int) is the amount of the available small tiles (1ft), num_large (int) is the amount of the available large tiles (5ft), and length (int) is the length (in ft) you want to cover. Return value: True if the available tiles can fit exactly the given length and False otherwise. Examples:tile_fitting(5,4,11) → Truetile_fitting(1,3,13) → Falsetile_fitting(0,3,10) → True

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

You know the right answer?

You have tiles of two different fixed sizes, 1ft and 5ft long, and you want to decide whether a cert...