Engineering, 15.02.2020 05:25 summerhumphries3

Objectives: This exercise aims to get you started with the Assembly language. You will get the experience of defining variables, using the Irvine library procedures for I/O and perform some basic integer arithmetic. Description: Write a MASM program to perform the following tasks: 1. Display your name and program title on the screen. 2. Display instructions to the user 3. Prompt the user to enter two (2) numbers 4. Calculate the sum, difference, product, integer quotient and remainder of the numbers. 5. Display the results 6. Say goodbye Requirements: 1. The main procedure must be divided into the following sections: a. Introduction b. Get the data c. Calculate the required values d. Display the results e. Say goodbye Notes: 1. A program template is available on CANVAS 2. You are NOT required to handle negative / floating-point inputs or.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

You know the right answer?

Objectives: This exercise aims to get you started with the Assembly language. You will get the exper...