Engineering, 14.02.2020 00:12 ICyberAngel
Hot water at an average temperature of 88°C and an average velocity of 0.4 m/s is flowing through a 5-m section of a thin-walled hot-water pipe that has an outer diameter of 2.5 cm. The pipe passes through the center of a 14-cm-thick wall filled with fiberglass insulation (k = 0.035 W/m·K). The surfaces of the wall are at 18°C. a. Determine the rate of heat transfer from the pipe to the air in the rooms. b. Determine the temperature drop of the hot water as it flows through the 5-m-long section of the wall where the steady rate of heat transfer from the pipe is 39.153 W. For water, use density (rho) 1000 kg/m^3 and specific capacity of heat (cp) =4180 J/kg.°C.
Answers: 1
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
Hot water at an average temperature of 88°C and an average velocity of 0.4 m/s is flowing through a...
Biology, 26.08.2019 11:20
History, 26.08.2019 11:20
Mathematics, 26.08.2019 11:20
Health, 26.08.2019 11:20