Engineering, 12.02.2020 05:19 Tyrant4life

A flight consultant wishes to model the process by which an airplane allows any charge build-up acquired in flight to leak off. She is aware that planes have needle shaped metal extensions on the wings and tail to accomplish this and that the process works, because the electric field around the needle is much larger than around the body of the plane, causing dielectric breakdown of the air and discharging the plane. Her model consists of two conducting spheres connected by a conducting wire. The sphere representing the plane has a radius of 6.00 m, the sphere representing the tip of the needle has a radius of 2.00 cm, and a total charge of 78.0 µC is placed on the combination.
(a) Determine the electric potential (in V) at the surface of each sphere.
(b) Determine the electric field (in V/m) at the surface of each sphere.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:10, jesuslovesusall3

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

You know the right answer?

A flight consultant wishes to model the process by which an airplane allows any charge build-up acqu...