subject
Engineering, 12.02.2020 01:34 nallwly

A). If the rat were twice as long (20 cm), how many square centimeters of skin would be heating each cubic centimeter of body? (Hint: this is the surface-to-volume ratio.)

cm2 skin per cm3 body

b)Absorbed Radiation = (exposed area) × (solar radiation) × (absorption)
In the heat of the day in the Sonoran desert, the Sun produces around 0.1 watts / cm2. Assume 1/2 the skin of the k-rat is exposed to solar radiation (recall total k-rat skin area is 315 cm2), and that the k-rat absorbs 50% of that radiation (absorption = 0.5). Using those numbers, answer the following question.
Calculate the heat gain from solar radiation and type this value into the Absorbed Radiation box on the right.

c)Assuming the k-rat has a mass of 30 grams, calculate how much metabolic heat it generates at rest.

d) conduction rate

e) the ground were at 303 K, how much heat would move into the k-rat by conduction

f) If the kangaroo rat were to lose that heat by water loss (the only mechanism left in the heat balance equation), how much water (in ml) would it need to lose every hour

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, theamandawhite
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
image
Engineering, 04.07.2019 12:10, Ryantimes2
On a average work day more than work place firs are reorted
Answers: 1
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:20, maustin5323
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
You know the right answer?
A). If the rat were twice as long (20 cm), how many square centimeters of skin would be heating each...

Questions in other subjects: