Engineering, 11.02.2020 20:57 ella3714

Find the value of R2 required if vs = 18 V , R1 = 50 kΩ , and the desired no-load output voltage is vo = 6 VPart b)Several different loads are going to be used with the voltage divider from Part A. If the load resistances are 300 kΩ , 200 kΩ , and 100 kΩ , what is the output voltage that is the most different from the design output voltage vo = 6 V ?part c)The circuit designer wants to change the values of R1 and R2 so that the design output voltage vo = 6 V is achieved when the load resistance is RL = 200 kΩ rather than at no-load. The actual output voltage must not drop below 5.4 V when RL = 100 kΩ . What is the smallest resistor value that can be used forR1?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, danksans7011

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, colin774

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

continue

You know the right answer?

Find the value of R2 required if vs = 18 V , R1 = 50 kΩ , and the desired no-load output voltage is...