subject
Engineering, 11.02.2020 20:52 vanessacox45

Assuming that the center of gravity is in the center of the bucket directly below the hook block, determine the following about the rigging system and hoist line used to lift a fully loaded concrete bucket.

a) The applied load in each chain

b) The tension in the hoist line

c) The rigging system that is most cost effective. Cost effectiveness is determined by the formula:

Price / Factor of Safety (FoS) where FoS = Rated Capacity/Applied Load

d) The maximum weight that can be lifted without failure of the 3-chain rigging system

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
image
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
image
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
Assuming that the center of gravity is in the center of the bucket directly below the hook block, de...

Questions in other subjects:

Konu
English, 11.10.2019 01:50
Konu
Mathematics, 11.10.2019 01:50