subject
Engineering, 11.02.2020 20:37 Lscifa

Given the dimensions in the figure above, and the following data:

Water Temperature: 21.6 degrees celsius

(Depth = Depth of the water in each trial and there was seven trials)

(Mass = Mass of each trial needed to equalize the beam)

1. Compare the theoretical force with the measured force. The measured force is obtained by setting the summation of moments about the pivot point equals to zero. However, the calculation involved the assumption that the center of pressure can be calculated from the equation provided below.

2. Also confirm that if depth is less than 100mm, the center of pressure is located h/3 from the bottom of the quadrant(h=depth of water). Explain why the center of pressure is NOT located at a distance h/3 from the bottom of the quadrant for depths greater than 100mm.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
image
Engineering, 04.07.2019 19:10, babas97
What is a monomer? how do they form a ploymer from the view point of chemical bonding?
Answers: 1
image
Engineering, 06.07.2019 03:20, crazylife77
What is the strain energy stored in a solid uniformly circular shaft of length 3.0 m and diameter 120 mm when subject to pure torsion if the maximum shear stress is 40 mpa? g-80gpa
Answers: 1
image
Engineering, 06.07.2019 04:30, dylanpierce34
What does stp and ntp stands for in temperature measurement?
Answers: 3
You know the right answer?
Given the dimensions in the figure above, and the following data:

Water Temperature: 21....

Questions in other subjects:

Konu
Mathematics, 07.12.2020 16:40