Engineering, 11.02.2020 17:15 fdelacruz19

You have a Switch LED Lightbulb with the following information:
It is equivalent to a 75 Watt incandescent lightbulb.
It uses 20 Watts of electricity.
It is estimated to last 25,000 hours.
The purchase price of the lightbulb is $51.99.
The package claims an estimated energy cost of $2.41 per year, but this estimate is not based on local electricity costs.
Assume that local electricity costs $0.086 per kW-hr.
Based on this information, we can now calculate the cost of ownership for this bulb. The cost of ownership is defined as the purchase price of the lightbulb plus the cost of the electricity required to run the lightbulb until failure.
Note the equation below: Purchase price + Total electricity cost = Cost of ownership Calculate the cost of ownership for this lightbulb. Then select the answer below that matches your calculation.
a. $40.14
b. $51.99
c. $94.99
d. $103.98

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 04.07.2019 18:20, 21megoplin

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

continue

Engineering, 04.07.2019 19:10, lexie223

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

continue

Engineering, 04.07.2019 19:20, GusGus11

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

continue

You know the right answer?

You have a Switch LED Lightbulb with the following information:
It is equivalent to a 75 Watt...