subject
Engineering, 29.01.2020 03:42 marvin07

Asample of blue gray soil was obtained from the seattle waterfront to determine its atterberg limits and classify it's soil type according to the unified soil classification system. for one of the pl determinations, the wet weight + dish = 22.24 grams and the dry weight + dish = 15.63 grams. the dish only weighed 5.72 grams. compute the plastic limit. three determinations of the liquid limit were made. for 17 blows, the water content was 89%; for 26 blows, the water content was 78%; and for 36 blows, the water content was 69%. the soil had no organics and contained 20% sand. evaluate the soil type, plot the plasticity information on a plasticity chart, and give the unified soil classification symbol.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, namira16
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
image
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
image
Engineering, 04.07.2019 19:20, zoebtharpe
Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection
Answers: 1
You know the right answer?
Asample of blue gray soil was obtained from the seattle waterfront to determine its atterberg limits...

Questions in other subjects:

Konu
Mathematics, 11.03.2021 01:00
Konu
Mathematics, 11.03.2021 01:00