Engineering, 27.01.2020 23:31 dward5823

The table given below is the calibration data for a typical pressure gauge. a. plot this calibration data and present the plot. explain which data you consider the 'known' value and why. b. if my pressure gauge reads 42 psi, what is the corresponding corrected pressure value on the downscale (while decreasing pressure)? c. explain why it is necessary to measure both increasing and decreasing pressures for the calibration curves. deadweight tester (psi) bourdon gauge (psi) 20 42 65 81 108 100 120 140 160 180 200 200 180 160 121 145 161 184 205 205 140 120 100 188 168 149 129 110 85 66 44 21

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:20, yasyyas646646

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

continue

Engineering, 04.07.2019 18:20, xcapo1x

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

continue

You know the right answer?

The table given below is the calibration data for a typical pressure gauge. a. plot this calibration...