Engineering, 25.01.2020 03:31 harveyangel123p2tjae

Exactly 5.00 ml aliquots of a solution containing phenobarbital were measured into 50.00ml volumetric flasks and made basic with koh.
the following volumes of a standard solution of phenobarbital containing 2.00 µg/ml of phenobarbital were then introduced into each flask and the mixture was diluted to volume: 0.00, 0.500,1.000, 1.50, and 2.00ml.
the fluorescence of each of these solutions was measured with a fluorometer, which gave volumes of 3.26, 4.80, 6.41, 8.02, and 9.56 respectively.

(a) pot the data.
(b) using the plot from (a) calculate the concentration of phenobarbital in the unknown.
(c) derive a least-squares equation for the data.
(d) find the concentration of phenobarbital from the equation in (c)
(e) calculate a standard deviation for the concentration obtained in (d)

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:20, safiyabrowne7594

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

continue

Engineering, 04.07.2019 19:20, mariahmimibrooks

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

continue

Engineering, 04.07.2019 19:20, molly7654

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

continue

You know the right answer?

Exactly 5.00 ml aliquots of a solution containing phenobarbital were measured into 50.00ml volumetri...