subject
Engineering, 03.01.2020 05:31 holytreesaroy

Astudent team is to design a human-powered submarine for a design competition. the overall length of the prototype submarine is 4.85 m, and its student designers hope that it can travel fully submerged through water at 0.440 m/s. the water is freshwater (a lake) at t = 15 °c. the design team builds a one-fifth scale model to test in their university’s wind tunnel. a shield surrounds the drag balance strut so that the aerodynamic drag of the strut itself does not influence the measured drag. the air in the wind tunnel is at 25°c and at one standard atmosphere pressure. the students measure the aerodynamic drag on their model submarine in the wind tunnel. they are careful to run the wind tunnel at conditions that ensure similarity with the prototype submarine. their measured drag force is 5.75 n. "estimate the drag force" on the prototype submarine at the given conditions.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
image
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
Astudent team is to design a human-powered submarine for a design competition. the overall length of...

Questions in other subjects:

Konu
Mathematics, 12.12.2020 16:30
Konu
Mathematics, 12.12.2020 16:30