Engineering, 28.12.2019 04:31 aspenbaxter201634

Given the following access-control list: access-list 90 deny 10.168.7.0 0.0.0.255 access-list 90 permit host 10.168.7.10 access-list 90 permit host 10.168.7.11 access-list 90 permit host 10.168.7.12 access-list 90 deny any what would be the end result if the network security engineer applies access-list 90 to the inbound interface of fastethernet 0/3? group of answer choices a. the access-list will permit host 10.168.7.10 to pass through the router. b. the access-list will permit host 10.168.7.15 to pass through the router. c. denial of service for this network because the rules are not placed in the correct order. d. both hosts 10.168.7.10 and 10.168.7.11 will be permitted. e. the access-list will generate an error message.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

You know the right answer?

Given the following access-control list: access-list 90 deny 10.168.7.0 0.0.0.255 access-list 90 pe...