Engineering, 27.12.2019 06:31 kayleetweedy1

The 50mm diameter cylinder is made from am 1004-t61 magnesium (e = 44.7gpa, a = 26x10^-6/°c)
and is placed in the clamp when the temperature is t1 = 15°c. if the two 304-stainless-steel (e =
193gpa, a = 17x10^-6/°c) carriage bolts of the clamp each have a diameter of 10mm, and they hold
the cylinder snug with a negligible force against the rigid jaws, determine the temperature at which
the average normal stress in either the magnesium or steel becomes 12 mpa.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:20, ashleyjaslin

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

You know the right answer?

The 50mm diameter cylinder is made from am 1004-t61 magnesium (e = 44.7gpa, a = 26x10^-6/°c)
a...