subject
Engineering, 24.12.2019 20:31 JJ143899

Assume that a diaphyseal cross section carries a bending moment m. let the cross section be circular with inner and outer diameter of 20 and 30 mm, respectively, and assume that the neutral axis (na) passes through the centroid. draw the cross section and write an equation for the normal stress σ, as function of angular position θ measured from the neutral axis. assume that modeling adds or removes bone on the periosteal and endosteal surfaces at a rate proportional to the local longitudinal stress on the surface: ( ) m f / r = −kσ θ ,where the apposition rate mf / r is negative for tensile stress and positive for compressive stress and the rate of constant k is the same for each kind of modeling and each surface. sketch a line adjacent to the original periosteal surface that would represent the circumference after some arbitrary period of time. do the same for the endosteal surface. (scale your sketch so that the maximum thickness of bone added is about half the orginal cortical thickness.) what happened to the bone’s cross-sectional geometry? would this change be advantageous in some way?

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, yasminothman02
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
image
Engineering, 04.07.2019 18:10, Larkinlover703
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
image
Engineering, 04.07.2019 18:10, namira16
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Assume that a diaphyseal cross section carries a bending moment m. let the cross section be circular...

Questions in other subjects:

Konu
Mathematics, 04.10.2020 14:01
Konu
English, 04.10.2020 14:01