subject
Engineering, 19.12.2019 20:31 winnie45

In a dairy operation, milk at a flow rate of 250 liter/hour and a cow body temperature of 38.6 degree c must be chilled to a safe-to-store temperature of 13 degree c or less. ground water at 10 degree c is available at a how rate of 0.72 m^3/h. the density and specific heat of milk are 1030 kg/m^3 and 3860 j/kg k, respectively, determine the outlet temperature of the water. determine the ua product of a counterflow heat exchanger required for the chilling process. determine the length of the exchanger if the inner pipe has a 50-mm diameter and the overall heat transfer coefficient is u = 1000 w/m^2 k. using the value of ua found in part (a), determine the milk outlet temperature if the water flow rate is doubled. what is the outlet temperature if the flow rate is halved?

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, viicborella
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, salazjlove
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
image
Engineering, 04.07.2019 18:10, krystabrewer3
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
You know the right answer?
In a dairy operation, milk at a flow rate of 250 liter/hour and a cow body temperature of 38.6 degre...

Questions in other subjects: