Engineering, 19.12.2019 06:31 lakeshia8880

Acompression spring is needed to fit over a 0.5-in diameter rod. to allow for some clearance, the inside diameter of the spring is to be 0.6 in. to ensure a reasonable coil, use a spring index of 10. the spring is to be used in a machine by compressing it from a free length of 5 in through a stroke of 3 in to its solid length. the spring should have squared and ground ends, unpeened, and is to be made from cold-drawn wire.

(a) determine a suitable wire diameter.
(b) determine a suitable total number of coils.
(c) determine the spring constant.
(d) determine the static factor of safety when compressed to solid length.
(e) determine the fatigue factor of safety when repeatedly cycled from free length to solid length, using the gerber fatigue failure criterion with zimmerli data.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

You know the right answer?

Acompression spring is needed to fit over a 0.5-in diameter rod. to allow for some clearance, the in...