Engineering, 17.12.2019 05:31 taehyungg

)steam (6000 kg/h, 10 bar, 400oc) is passed through an adiabatic turbine that drives a shaft to generate power. the steam leaving the turbine is at 0.5 bar and passes to a chiller where heat is removed at the rate of 1.25 x 107 kj/h. saturated liquid leaves the chiller at 0.5 bar.
how much work (kw) is produced in the turbine?
what is the quality of steam leaving the turbine? sometimes, steam produced is ‘wet’ in nature, and is composed of saturated water vapor and entrained water droplets. in such cases, quality is defined as the fraction of steam that is vapor.
i haven't been able to get this as the final answer.

final (a) 1400 kw; (b) 0.9

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 19:20, diawia

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

continue

Engineering, 06.07.2019 03:20, demotte79991

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

continue

You know the right answer?

)steam (6000 kg/h, 10 bar, 400oc) is passed through an adiabatic turbine that drives a shaft to gene...