Engineering, 14.12.2019 05:31 tciara788

Air at 25c, 100kpa and ait at 50 c 200 kpa at 1: 1 volume ratio are mixed inside an adiabatic compressor to 55c and pushed through an isothermal nozzle with and inlet area a quarter size of the outlet area and reaching 10m/s at 300 kpa. how much work is required if we want to get 5kg of this mixture. assume fluid velocity is negligible before the compressor and the gases are ideal with constant specific heats.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 19:10, nayi2002

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

continue

Engineering, 04.07.2019 19:10, jrcspiderman2003

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

continue

You know the right answer?

Air at 25c, 100kpa and ait at 50 c 200 kpa at 1: 1 volume ratio are mixed inside an adiabatic compre...