Engineering, 12.12.2019 21:31 rosieposie27

The velocity potential for a certain inviscid, incompressible flow field is given by the equation:
φ = 2x^y - (2/3) y^3
where φ has the units of m^2/s when x and y are in meters. determine the pressure at the point x = 2.3 m, y = 2.3 m if the pressure at x = 1 m, y = 1 m is 1900 kpa. elevation changes can be neglected, and the fluid is water.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 19:10, nayi2002

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

You know the right answer?

The velocity potential for a certain inviscid, incompressible flow field is given by the equation:...