subject
Engineering, 12.12.2019 05:31 teddybear8728

Acombined power cycle relies on a gas turbine cycle and a rankine cycle. heat is fed to the gas turbine combustor at a rate of 50 mw. the gas turbine cycle operates at an efficiency of 0.35. the gas that exhausts from the turbine is still hot and is used to boil water in the rankine cycle. the rankine cycle operates at an efficiency of 0.42.

find:
a) the total power produced by the combined cycle

b) the efficiency of the combined cycle
c) the rate of heat rejection from the rankine cycle

d) if the rankine boiler is operating at a pressure of 2 mpa and the steam enters the turbine at a temperature of 300 c, what is the mass flow rate of water through the rankine engine? you may assume that the water leaving the pump is saturated liquid at 2 mpa.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:10, jimena15
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
image
Engineering, 04.07.2019 19:20, diawia
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
image
Engineering, 06.07.2019 03:20, mardell2587
Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing
Answers: 3
You know the right answer?
Acombined power cycle relies on a gas turbine cycle and a rankine cycle. heat is fed to the gas turb...

Questions in other subjects: