subject
Engineering, 11.12.2019 21:31 Apple557

You are inside a small (125 m3) laboratory, using liquid nitrogen at rate of 3 l/min from a large, insulated container. the liquid nitrogen expands as it evaporates, mixing with the air in the room (there is a fan that ensures that it is well-mixed), and all gases behave ideally. air leaves the room through a small crack in the door, such that the volume, pressure and temperature of the gas in the room all remain constant at 125 m3, 1 atm and 24°c, respectively. therefore, the mole fractions of nitrogen and oxygen are both time dependent. using the knowledge that the composition of normal air is 79% n2/21% o2, and that oxygen deprivation becomes a threat below 18% o2, calculate the maximum time (in minutes) that you can safely remain in the laboratory after starting the flow of nitrogen.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 19:30, 10040813
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
image
Engineering, 04.07.2019 18:20, AnonymousLizard52303
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
image
Engineering, 04.07.2019 19:10, netflixacc0107
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
You know the right answer?
You are inside a small (125 m3) laboratory, using liquid nitrogen at rate of 3 l/min from a large, i...

Questions in other subjects:

Konu
Mathematics, 23.09.2019 04:00
Konu
Physics, 23.09.2019 04:00
Konu
Mathematics, 23.09.2019 04:00
Konu
Biology, 23.09.2019 04:00