subject
Engineering, 11.12.2019 06:31 kaylah71

1. a spherical storage tank has a radius of 3 meters and contains a drain plug at the bottom with a radius of 3 cm. using fluid mechanics principals, an ode of the change in height in time is given by the following equation: ℎ − ℎ 2 ) ℎ = −√ℎ where is the radius of the storage tank, is the cross-sectional area of the drain, and is a unit less experimentally determined value based on the type of fluid. use = 9.81, = 0.6, and an initial height of 5.9 meters. run the ode23 solver for 3 hours, you will get negative height results, delete these values. produce a single plot of the results and confirm that it matches the solution in your previous homework (no specific confirmation step required, but if it does not match you may not have used the function correctly). print the time it took to drain in the following format using fprintf: it took hh: mm: ss to drain.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, soreese02
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
image
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
image
Engineering, 04.07.2019 18:20, RiverH246
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
You know the right answer?
1. a spherical storage tank has a radius of 3 meters and contains a drain plug at the bottom with a...

Questions in other subjects:

Konu
Computers and Technology, 24.07.2019 17:00
Konu
Computers and Technology, 24.07.2019 17:00
Konu
Computers and Technology, 24.07.2019 17:00