Engineering, 10.12.2019 03:31 Shazrts2371

A. draw the hierarchy chart and then plan the logic for a program that calculates a person's body mass index (bmi). bmi is a statistical measure that compares a person's weight and height. the program uses three modules. the first prompts a user for and accepts the user's height in inches. the second module accepts the user's weight in pounds and converts the user's height to meters and weight to kilograms. then, it calculates bmi as weight in kilograms divided by height in meters squared, and displays the results. there are 2.54 centimeters in an inch, 100 centimeters in a meter, 453.59 grams in a pound, and 1,000 grams in a kilogram. use named constants whenever you think they are appropriate. the last module displays the message end of job. b. revise the bmi-determining program to execute continuously until the user enters 0 for the height in inches.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

You know the right answer?

A. draw the hierarchy chart and then plan the logic for a program that calculates a person's body ma...