subject
Engineering, 10.12.2019 03:31 ian2006huang

Explain the system of united states public land survey system (plss) utilizing the following terms: of these terms lends itself to understanding this system of measurement and should be analyzed in regards to: use in locating placeswhere this systems of measurement is usedany other important information you find through researchalso include in your answer the following: how a location in the united states is identified using plssall of the terms listed abovein addition to this information conduct additional research to identify if the state of nevadai uses plss and if so, what is the name of the principal meridian used to located places in that state as well as where the intersection of said principal meridian and baseline is located.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:10, alex6toes
What are the major differences between injection molding and extrusion?
Answers: 2
image
Engineering, 06.07.2019 02:30, chickennbutt0730
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
image
Engineering, 06.07.2019 02:30, cofran
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
You know the right answer?
Explain the system of united states public land survey system (plss) utilizing the following terms:...

Questions in other subjects: