subject
Engineering, 09.12.2019 19:31 roxequartz

The statement that is not true about the difference between laminar and turbulent boundary layers is: a. the reynolds number for a turbulent boundary layer is higher than that for a laminar boundary layer. b. the wall shear stress for a turbulent boundary layer is greater than that for a laminar boundary layer. c. a turbulent boundary layer is thicker than a laminar boundary layer. d. the velocity gradient at the wall is greater for a laminar boundary layer than a turbulent boundary laye

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, AnonymousLizard52303
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
image
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
image
Engineering, 06.07.2019 05:10, dundiedoo7196
Explain linear and angular momentum analysis for flow systems.
Answers: 2
image
Engineering, 06.07.2019 05:30, pr47723
There is a sweet potato with an initial uniform temperature of 25 c and it has an average diameter of 70 mm. thermal conductivity and diffusivity of the potato are 0.62 w/m c and 0.2 x 10^-6 m^2/s. respectively. it is to be cooled by refrigerated air at 1.8°c flowing at a velocity of 4 m/s. the average heat transfer coefficient between the potato and the air is 25 w/m2·°c. determine how long it will take for the center temperature of the potato to drop to 5.5°c
Answers: 1
You know the right answer?
The statement that is not true about the difference between laminar and turbulent boundary layers is...

Questions in other subjects:

Konu
Mathematics, 03.12.2020 19:50
Konu
Mathematics, 03.12.2020 19:50
Konu
Mathematics, 03.12.2020 19:50