Engineering, 07.12.2019 01:31 kim643

For an n-channel mosfet with gate oxide (sio2) thickness of 30 nm, threshold voltage of 0.7 v, z = 30 um, and length of the device is 0.9 μm, calculate the drain current for vg-3 v and vd-0.2 v. assume that the electron channel mobility is 200 cm'/v-sec. what will be the required drain current to drive the mos in saturation region? how the drain current will change if hfo2 with ks 25 will be used as a gate oxide, whereas other mosfet parameters will be kept the same. what did you mention?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

Engineering, 04.07.2019 19:10, jrcspiderman2003

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

continue

You know the right answer?

For an n-channel mosfet with gate oxide (sio2) thickness of 30 nm, threshold voltage of 0.7 v, z = 3...