Engineering, 06.12.2019 01:31 butterscotchsjoqsvoz

Aspeed-reducer gearbox containing a compound reverted gear train transmits 45 horsepower with an input speed of 1200 rev/min. spur gears with 20◦ pressure angle are used, with 16 teeth on each of the small gears and 48 teeth on each of the larger gears. a diametral pitch of 10 teeth/in is proposed.
(a) determine the speeds of the intermediate and output shafts.
(b) determine the pitch line velocities (in ft/min) for each set of gears.
(c) determine the magnitudes of the tangential, radial, and total forces transmitted between each set of gears.
(d) determine the input torque.
(e) determine the output torque, neglecting frictional losses.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 19:20, littlepotato10

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

continue

Engineering, 06.07.2019 03:20, cherkaouinazihp387bk

Figure out the odd statement about ceramics in the following (a) good insulators of heat and electricity (b) usually less desire than metals (c) ductile in nature (d) contains both metallic and nonmetallic elements

Answers: 3

continue

You know the right answer?

Aspeed-reducer gearbox containing a compound reverted gear train transmits 45 horsepower with an inp...