subject
Engineering, 06.12.2019 01:31 nulledcracker12

You purchased a computer with the following features: • 95% of all memory accesses are found in the cache.• each cache block is two words, and the whole block is read on any miss.• the processor sends references to its cache at the rate of 109 words per second.• 25% of those references are writes.• assume that the memory system can support 109 words per second, reads or writes.• the bus reads or writes a single word at a time (the memory system cannot read or write two words at once).• assume at any one time, 30% of the blocks in the cache have been modified.• the cache uses write allocate on a write miss.• you are considering adding a peripheral to the system, and you want to know how much of the memory system bandwidth is already used. calculate the percentage of memory system bandwidth used on the average in the two cases below. be sure to state your assumptions. a. case 1: the cache is write through. b. case 2: the cache is write back.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
image
Engineering, 04.07.2019 18:20, safiyabrowne7594
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
image
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
You purchased a computer with the following features: • 95% of all memory accesses are found in the...

Questions in other subjects:

Konu
Mathematics, 10.03.2021 20:50
Konu
Mathematics, 10.03.2021 20:50
Konu
Mathematics, 10.03.2021 20:50
Konu
Mathematics, 10.03.2021 20:50